Page 2 of 3

This use of slot dies is called "patch coating." (See Figure 2.) In this type of coating, materials are applied intermittently, at controlled intervals along a continuous web or onto discrete sheets or panels. In an automated process, special valves start and stop coating application; this action is coordinated with movement of the die toward and away from the substrate to promote a clean break in the coating and prevent formation of edge beads. Like other slot die systems, patch coaters are closed systems that apply coating materials in amounts pre-determined by the action of a pump that meters material into the coating head.

Few solar manufacturers have been aware of slot die coating and its advantages over other coating methods, such as spray, roll, and spin coating. In comparison with these systems, slot dies provide greater control over coating weight and distribution because they are closed systems into which coating material is pumped at closely pre-determined rates; in turn this greater control makes possible thinner coatings. Since material in the conventional systems is exposed to the atmosphere prior to being applied, slot dies also present less risk of contamination and reduce emissions into the workplace.

Tomorrow's Solar Systems: Continuous Thin Film

As an offshoot of the semiconductor industry, the solar electric industry until now has had little contact with the roll-to-roll, continuous-web production methods familiar to flat die builders and their customers. The ultimate reason for this is the batch process used to fabricate the PV material in most of today's solar applications: crystalline silicon semiconductor. It literally must be sliced into wafers, which are then paired to form cells. The discrete rigid panels that are today's most recognized solar electrical devices reflect the need to interconnect many discrete cells to form a module.

Increasingly the solar energy industry is looking to continuous thin-film technology as the key to bringing down the manufacturing costs of electric systems. What makes such roll-to-roll production possible is the replacement of rigid crystalline silicon with amorphous silicon supplied in a high-solids slurry that can be deposited onto a substrate by means of web-converting processes such as slot die coating. Though lower in PV efficiency than crystalline silicon, the amorphous semiconductor material is less costly, and this, combined with the automation made possible by roll-to-roll production, can bring down the cost of solar electricity generation. At the same time, the more extensive installations made possible by the thin film form helps offset the losses in PV efficiency.

One of the ultimate goals of thin-film solar technology, for example, is to produce PV film in large quantities of rollstock that can be sold to general contractors for installation atop houses and commercial buildings.

PV systems like these are a logical next step, as techniques already have been refined to apply conductive slurries onto a range of substrates in high-specification applications, including flexible batteries. For example, patch-coating techniques have been developed for simultaneously applying anode and cathode slurries to both sides of films or metal foils for lithium ion batteries. And for continuous-web products like thin film solar systems, "lane coating" methods have been developed to apply conductive and semiconductive materials.

While patch coating involves uncoated intervals in the transverse direction, lane coating leaves continuous uncoated lanes in the machine direction, alternating with coated lanes. Using two dies, systems have been developed for simultaneously coating two sides of a substrate with up to 48 separate lanes, each 20 mm wide and separate from other lanes by 10 mm gaps. The coating fluid has been applied in register on both sides--a critical requirement for preventing short circuits.

A typical thin film solar system would include polymer films, foil substrates, and up to six active coatings, each of which would require curing and thus could not be applied simultaneously with any of the others. One possible structure, from sun-facing side to back side, might look like this: polyethylene terephthalate (PET) film with UV-block coating; EVA protective layers; PET barrier film; a multi-component PV sandwich; a spacer film; a reflective film; an aluminum foil layer; and an EVA back layer. The PV sandwich would include amorphous silicon semiconductor, electrode, and other layers, including special coatings.